Sony DAVLF1H - Manual (Page 34)

34 US
You can hang the IR transmitter and IR receiver
on a wall when:
– there is an obstruction between the IR
transmitter and the IR receiver.
– people often pass between the IR transmitter
and the IR receiver.
When hanging both the IR transmitter and IR
receiver, adjust the position of the IR transmitter
after deciding the position of the IR receiver.
Installing the IR transmitter
on a wall
1
Rotate the stand of the IR transmitter.
2
Install 2 commercially available screws in
the wall so that it protrudes 4 mm (
3
/
16
inches).
Install the screws 30 mm (1
3
/
16
inches) apart.
3
Hang the IR transmitter via hole on the
bottom of the stand on the screw.
Make sure that the IR transmitter does not
move after installation.
Tip
• You can store the cords in the troughs in the bottom
of the stand.
Note
• Use screws suitable for the material and strength of
the wall.
• Do not install the IR transmitter to a wall of low
strength.
• Sony is not liable for any damage or accident incurred
by incorrect installation (i.e. low strength wall, etc.),
incorrect use of this product, or natural disaster.
• When connecting/disconnecting the cord, detach the
IR transmitter from the wall first.
Installing the IR
Transmitter and the IR
Receiver on a Wall
Stand
IR transmitter
30 mm
(1
3
/
16
inches)
4 mm (
3
/
16
inches)
5 – 7 mm
( 7 /
32
– 9 /
32
inches)
IR transmitter
Stand
Troughs
Stand