Sharp DK-CL5P - Manual (Page 21)

21
2010 November 3 DK-CL5P_A6 02-27.fm
DK-CL5P
Radio
Listening to the radio (continued)
Notes:
● When radio interference occurs, auto scan tuning may stop
automatically at that point.
● Auto scan tuning will skip weak signal stations.
● To stop the auto tuning, press the TUNING ( s or r ) button again.
Receiving an FM stereo transmission:
● If the FM reception is weak, the reception will auto changes to
monaural, and the sound becomes clearer.
■ Programming a station
You can store 20 FM stations in memory and recall them at the
push of a button. (Preset tuning)
3 Tune to the desired station.
Main Unit
Manual tuning:
Rotate the TUNING (
s or r ) knob clockwise or counter
clockwise to tune into the desired station.
Remote Control
Manual tuning:
Press the TUNING (
s or r ) button as many times as
required to tune in to the desired station.
Auto tuning (remote control only):
When the TUNING (
s or r ) button is pressed for more
than 0.5 seconds, scanning will start automatically and the
tuner will stop at the first receivable broadcast station.
1 Perform steps 1 - 3 in “Tuning” on pages 20 - 21.
2 Press the CLOCK/MEMORY button for more than 2
seconds on the main unit or remote control to enter
the preset tuning saving mode.
3 Within 7 seconds, press the or button on the
main unit or s or r button on the remote control to
select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4 Within 7 seconds, press the CLOCK/MEMORY button
to store that station in memory.
If the preset number indicators disappear before the
station is programmed, repeat the operation from step 2.
5 Repeat steps 1 - 4 to set other stations, or to change a
preset station.
When a new station is stored in memory, the station
previously programmed for that preset channel number will
be erased.
MON
MON MON