Sharp 25N S180 - Manual (Page 30)

30
6
Press MENU to exit.
• Poor reception due to weak signals, or too much noise might activate the BLUE SCREEN function
despite the presence of a broadcast signal. To continue watching TV under these conditions, switch
the BLUE SCREEN “OFF”.
• While VCR input mode is selected, the BLUE SCREEN will not be shown on your TV even if the
BLUE SCREEN is turned on.
L PERSONAL PREFERENCE
By setting the PERSONAL PREFERENCE channels in advance,
you can select your favorite channels easily.
1 Press MENU to access MAIN MENU screen.
2
Press CH UP ( 8 ) or DOWN ( 9 ) to move the “ ” mark to
“SET UP”.
3
Press VOL (+) or (–) to access SETUP mode, then press
CH UP ( 8 ) or DOWN ( 9 ) to move the “ ” mark to “PERSONAL
PREFERENCE”.
4
Press VOL (+) or (–) to select PERSONAL PREFERENCE select
mode in which you can program four favorite channels, in four
different categories. (total of 16 channels)
5
Press CH UP ( 8 ) or DOWN ( 9 ) to move the “ ” mark to the
desired position.
6 Press REMOTE KEYPAD on the Remote to input the CHANNEL
Number into the memory.
Example:
125 — Press “100” followed by “2” and then “5”.
7
Repeat steps 4 - 6 to input the next CHANNEL Number.
→
Set Up (Continued)
VOLUME
(+)/(–)
CHANNEL
UP (
8 )/
DOWN ( 9 )
MENU
(MAIN MENU screen)
REMOTE
KEYPAD
PERSONAL
PREFERENCE
(SETUP mode)
→
(PERSONAL PREFERENCE select mode)
NOTE:
26-31 25&27NS100/180 1.4 6/1/00, 2:11 PM 30