Samsung ITP-5107SIP - Manual (Page 48)

41
CUSTOMIZING YOUR KEYSET
AME PASSWORD
This feature allows people using the AME feature to enable password protection.
This will prevent unauthorized people from listening to your messages being left.
The passcode is the same as your station passcode. This feature only applies if
there is an SVMi card installed in the system and your keyset has a programmed
AME button.
• With the handset on-hook, press TRANSFER and then dial 110.
• Dial 101 to turn on AME PASSCODE or 100 to turn it off.
• Press TRANSFER to store your selection.
AUTO CAMP-ON
This option allows intercom calls to be automatically camped on, if possible, when
a busy station is called.
• With the handset on-hook, press TRANSFER and then dial 110.
• Press 081 to turn CAMP-ON on or 080 to turn it off.
• Press TRANSFER to store your selection.
SELECT RING TONE
Each keyset user can select any one of eight ring frequencies:
• While on-hook, press TRANSFER and then dial 111.
• Dial 1–8 or press the UP and DOWN buttons to hear each tone.
• When you hear the tone that you prefer, press TRANSFER to save it.
NOTE: Specific lines or stations may be programmed to ring with a different
tone than what you have selected for your keyset.
CHANGE YOUR PASSCODE
From the factory, your station passcode is 1234. You can change your station pass-
code whenever you desire.
• While on-hook, press TRANSFER and then dial 101.
• Dial your old passcode.
• Dial a new passcode (must be four characters). You can use 0–9.
• Redial the new passcode to verify. If successful, you will hear two beeps. Four
beeps indicate an incorrect code. Reenter the code again.
• Press TRANSFER to store the new passcode.
5107S_keyset.qxp 5/9/2006 9:56 AM Page 47