Cti calls – Siemens OPENSTAGE 20 5000 User Manual
Page 62
Step by step
Enhanced phone functions
62
CTI calls
Beep on auto-answer
Speakerphone mode activates automatically on your
phone if you use a CTI application (such as Outlook) to
dial a number when Auto Answer is active. If Auto An-
swer is not active, the phone rings first and you have to
press the loudspeaker key or lift the handset to set up
the call. This setting also defines whether or not incom-
ing calls are automatically accepted. If the function is
active, an alert beep sounds when an incoming call is
automatically accepted.
Information on the operation of the configured CTI ap-
plication can be found in the corresponding user guide.
z You can also configure this setting via the Web interface
Prerequisite: The option was programmed by your ser-
vice personnel.
N
Press the key shown.
Select and confirm the option shown.
if nec.
j
Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select the option shown and confirm twice.
User
Configuration
Incoming calls?
CTI calls?
f
Auto-answer = No
f
Yes
l
Beep on auto-answer = No
Yes
l
Option = Save & Exit
l