Sangean DT-300/DT-300V - Manual (Page 14)

5 8
11
12 11
5
8
On/off Button .Select desired band by pressing Band Select or Button .
Press Memory Button . Memo will flash in display. Press Select Button
for move than 2 seconds until auto/memo appears and flashes in display.
press memory Button again. The receiver will automatically begin to scan
and set memory preset positions. It will dliminate any memory presets already
with in the band.
F.Memory Scan Play
Turn on receiver by pressing On/Off Buttons .Select desired band by pressing
Band Selector Button .Select a preset station with in band selected. Make sure
the Select Cursor is in the Memory Position by pressing Select Button .
Press Tuning Control Button or for more than 1/2 second and release.
Display will show auto and flash The receiver will scan each preset,play for about
2 seconds and go on to the next preset. Press Tuning Control Button or
will stop scaning and select station desired.
L H
13 14
12
13 14
14