Sharp UX-300 - Manual (Page 65)

<P=002>
Changing the outgoing message
The outgoing message (OGM) of your answering machine should be
changed to inform callers who want to send a fax to press their Start
key. For example, your message might go as follows:
"Hello. You’ve reached the ABC company. No one is available to take
your call right now. Please leave a message after the beep or press
your facsimile Start key to send a fax. Thank you for calling."
Comments:
••••
Try to keep the length of the message under 10 seconds. If it is too long, you
may have difficulty receiving faxes sent by automatic dialing.
••••
If your outgoing message must be longer than 10 seconds, leave a pause of
about four seconds at the beginning of the message. This will give your fax a
chance to detect fax tones sent when automatic dialing is used.
Activating the Answering Machine Hookup
Before you go out, activate the answering machine hookup as follows:
1
Set the reception mode to A.M.
RECEPTION
MODE FAX TEL
A.M.
2
Set your answering machine to auto answer.
••••
Your answering machine must be set to answer on a maximum of
two rings. If not, you may not be able to receive faxes sent by
automatic dialing.
••••
If your answering machine has a toll saver function, make sure that
it will answer by the fourth ring.
6
. Ans
w
er
in
g
Ma
ch
in
e
Activating the Answering Machine Hookup
63