Samsung CLP-610 - Manual (Page 51)

7.7
<Troubleshooting>
5 Pull the jammed paper out in the direction shown. To avoid tearing
the paper, pull it out gently and slowly.
6 Close the front cover firmly. The machine will resume printing.
Caution
If the front cover is not completely closed, the machine will not
operate.
Understanding display messages
Messages appear on the Smart Panel program window or on the control
panel display to indicate machine status or errors. Refer to the tables
below to understand the messages meaning to correct the problem, if
necessary. Messages and their explanations are listed in alphabetical
order.
Note
• When you call for service, it is very convenient to provide the
service representative with the contents of the display message.
• If the message is not in the table, cycle the power and try the
printing job again. If the problem persists, call for service.
• Some messages may not appear in the display depending on
options or models. If so, it is not applicable to your machine.
* xxx indicates the media type.
* yyy indicates the tray.
Message Explanation Solution
[yyy]
Cassette Out The tray cassette is
not inserted, or not
properly closed. To close the tray,
lower the rear edge,
align it with the slot,
and slide it into the
printer.
[yyy]
Paper Empty There is no paper in
the tray. Load paper in the
tray. (Page 4.4)
ADC Not
Confirm Error There is a problem
in the ADC (Analog
to Digital Converter)
of your machine. Cycle power. If the
problem persists,
contact the service
representatives.
ADC Slope Error
Cycle Power The temperature
slope for ADC
(Analog to Digital
Converter) detects
the value out of the
normal range. Cycle power. If the
problem persists,
contact the service
representatives.
Adjusting...
Registration The machine is
adjusting the color
registration. Wait a few minutes.
Deve Motor
Locked There is a problem
with the
development motor
to machines which
moves the toner
supply device. Cycle power. If the
problem persists,
contact the service
representatives.
Door Open/Check
Transfer Belt The front cover or
the top cover is not
securely latched. Close the cover until it
locks into place.