Sony TA-FE370 - Manual (Page 8)

8 GB
Basic Operations
Listening to the music
1
Press ?/1 to turn on the amplifier and
turn VOLUME fully anticlockwise to
prevent damaging the speakers with
excessive output.
2
Turn on the programme source you
want to listen to.
3
Turn INPUT SELECTOR to select the
respective programme source.
To listen to a Select
Record PHONO
Radio broadcast TUNER
Compact disc CD
Source connected to AUX AUX
Source connected to:
– TAPE1/DAT
TAPE1/DAT
– TAPE2/MD TAPE2/MD
4
Start the programme source.
5
Adjust the volume by turning VOLUME.
To Press or turn
Adjust the bass BASS
Adjust the treble TREBLE
Adjust the balance BALANCE
Reinforce the bass and treble LOUDNESS
at low listening level
Tips
• If ?/1 is pressed down, you can turn the amplifier
on and off by pressing ?/1 on the remote.
• To listen through the headphones, connect the
headphones to PHONES and set SPEAKERS to
OFF.
• To listen directly to the input signal, press
SOURCE DIRECT so that the indicator lights up.
Since the circuits of TONE controls, BALANCE
control, and LOUDNESS button are bypassed, you
cannot adjust bass, treble, the balance, reinforce the
bass and treble while listening to a source directly.
Note
Avoid high speaker output at which the sound is
distorted. High-frequency distortion may damage the
tweeters.
To receive the Enhanced
Other Networks (EON)
programmes
(TA-FE570 only)
“Enhanced Other Networks (EON)” is one of
the convenient RDS services. This allows the
unit to automatically switch to a programme
type of your choice when one starts in your
broadcast area.
When your amplifier is connected to a Sony
tuner with the EON CONTROL system, the
amplifier switches to any EON programme that
is broadcast in your EON area, and switches
back to the last selected programme source
when the programme ends.
1
Make sure that the amplifier and the
tuner are connected through the EON
CONTROL terminals (see page 6).
2
Press EON LINK so that the indicator
lights up.
Whenever an EON programme starts on the
radio frequency that your tuner is set to, you
will receive it.
To cancel EON reception
Press EON LINK again so that the indicator
goes off.
Notes
• If you select another programme source while
receiving an EON programme, EON reception ends.
However, as long as the EON LINK indicator lights
up, you can receive EON programmes
automatically.
• Make sure to cancel EON reception before starting
to record since an EON programme may interfere
with your recording.
• If you activate the Tape Monitor function (see page
9) while the EON LINK indicator is lit, the
indicator goes off and you cannot receive EON
programmes. If this happens, deactivate the Tape
Monitor function so that the indicator lights up
again.