Step 4: setting up the wireless system, Step 4: setting up the wireless, System – Sony DAV-HDX277WC User Manual
Page 42
masterpage:Left
specdef v20071207
filename[E:\SS2008\Models\DCR2WC-2W-4WF\3283032111\3283032111_DAV-HDX277WC-
279W-576WF\gb04gst.fm]
model name [DAV-HDX277WC / HDX279W / HDX576WF]
[3-283-032-11(1)]
42
US
Ge
tting Star
te
d
Step 4: Setting up the
Wireless System
(DAV-HDX279W/DAV-HDX576WF only)
To use the wireless system, you need to set up
the surround amplifier. Before setting, make
sure that the wireless transceivers are inserted
into the unit and the surround amplifier correctly
(page 38).
This wireless system is called “S-AIR.” For
details of the S-AIR function, see “Using an
S-AIR Product” (page 83).
The unit transmits sound to the surround
amplifier that is connected to the surround
speakers. To establish sound transmission,
perform the following Steps.
1
Press "/1 on the unit.
The system turns on.
2
Make sure that the SURROUND
SELECTOR switch of the surround
amplifier is set to SURROUND.
3
Set the S-AIR ID switch of the surround
amplifier to A.
4
Press POWER on the surround
amplifier.
The POWER / ON LINE indicator turns
green. If not, check the transmission status
as follows.
To check the transmission status
You can check the status of sound transmission
between the unit and surround amplifier by
checking the POWER / ON LINE indicator of
the surround amplifier.
To enjoy the sound by using
headphones
You can enjoy the system’s sound in a place
apart from the unit by connecting the
headphones to the PHONES jack on the
surround amplifier.
Note
• When you connect headphones to the surround
amplifier, neither the unit nor the surround amplifier
outputs sound from the system’s speakers.
• The volume of the unit may become minimum if you
turn off the surround amplifier while the headphones
are connected to the surround amplifier, or radio
reception is poor. In this case, “HP NO LINK” and
“VOLUME MIN” appear alternately in the front
panel display. Check radio reception, and set the
volume again.
When you use the multiple S-AIR
product
You can prevent miss transmission between the
S-AIR products by setting a different ID for each
S-AIR product. For details, see “Establishing
sound transmission between the unit and S-AIR
sub unit (ID setting)” (page 83).
"/1
POWER
POWER/ON LINE
PHONES
R
SURROUND SELECTOR
S-AIR ID
EZW-RT
10
SPEAKER
SURROUND
PAIRING
C
B
A
SURROUND
BACK
L
POWER
POWER / ON LINE
Indicator
SURROUND
SELECTOR switch
S-AIR ID switch
PHONES jack
POWER / ON LINE
indicator
Status
Turns green.
Sound transmission is
established.
Flashes green.
Sound transmission is not
established.
For details, see “Surround
amplifier operation”
(page 105).
Turns red.
The surround amplifier does
not output sound.
For details, see “Surround
amplifier operation”
(page 105).
Turns off.
The surround amplifier turns
off or its protection is active.
For details, see “Surround
amplifier operation”
(page 105).