Chapter 11 : suuport tools, 1 record and load by ladder software, Chapter 11 support tools – Sharp JW-20CM User Manual

Page 188: 1 record and load by ladder software (jw-50sp)

Advertising
background image

11

·

1

Chapter 11 Support Tools

Select “Read out PARAM” and press the “Enter” key.

Start reading to memory of the personal computer.

The following support tools are available to record (store), and load the contents of the parameter memory.

(Make sure to save the set parameters onto a floppy diskette.)

11-1 Record and load by ladder software (JW-50SP)

(1) Record

Stop operation of the JW-20CM

Record onto the personal computer

After stopping operation, record the parameters of the JW-20CM onto the memory of the personal

computer.

Start operation of the JW-20CM

After recording the parameters onto the personal computer, start operation of the JW-20CM.

After selecting “Start write EEPROM” or “Execution

start,” press the “Enter” key.

Applicable floppy diskettes

Model name

Ladder software (JW-50SP)

3.5-inch 2DD/2HD, 5-inch 2DD/2HD

Multipurpose programmer (JW-50PG)

3.5-inch 2DD

Ladder processor II (Z-100LP2S)

3.5-inch 2DD

Start operation of the JW-20CM

After selecting “PC Run,” press the “Enter” key.

Start PC operation

Select “PC TRANS.”

Select “Read.”

Select “DL. M. stn. PARAM.” or “DL. S. stn.

PARAM.”

Set as the function setting condition of the
connected network module.

After selecting “PC stop,” press the “Enter”
key.

· Communication adaptor supplied

with JW-50SP

Convertor supplied with JW-50SP

· Control module connection cable

Advertising
This manual is related to the following products: