Sharp JW-20CM - Manual (Page 72)

8 · 34
• Remote I/O operation (communication) stops.
• The PC continues operation. (Mode 1)
• Only normal slave stations will continue
operation (communication).
• The PC continues operation. (Mode 2)
• Remote I/O operation (communication) stops.
• The PC also stops operation. (Mode 0)
• Remote I/O operation (communication) stops.
• The PC continues operation. (Mode 1)
• Only normal slave stations will continue
operation (communication).
• The PC continues operation. (Mode 2)
• Remote I/O operation (communication) stops.
• The PC continues operation. (Mode 1)
• Only normal slave stations will continue
operation (communication).
• The PC continues operation. (Mode 2)
• Remote I/O operation (communication) stops.
• The PC also stops operation. (Mode 0)
• Remote I/O operation (communication) stops.
• The PC continues operation. (Mode 1)
• Only normal slave stations will continue
operation (communication).
• The PC continues operation. (Mode 2)
001
002
004
005
006
011
012
014
015
016
From the previous page
Set remote I/O operation mode [OCT (octal, word)]
· Set operation method of the remote I/O into parameter address 000000
(8)
.
Set value (8)
Asynchronous
Synchronous
Asynchronous
Synchronous
· Concerning the contents of "synchronous" and "asynchronous" communications, see page 8·4
"Communication timing."
Set "slave station operation at error: mode 0" and "communication method: synchronous"
and "address allocation: manual"
To the next page
Display the
contents of
000000
(8)
Screen display of JW-13PG
After converting to octal
notation, write it at 014
(8)
.
17776 OCT 000
17777 OCT 000
I PARAM.
>00000 OCT 014
Operation method
Communication
method
Allocation of I/O address
Fixed allocation
Manual allocation
Operation when a slave station error occurs