Samsung 20041112183630062 - Manual (Page 21)

DSP
(Digital Signal Processor)
Modes
39 40
DSP modes have been designed to simulate different acoustic environments.
The sound heard in a hall, theater, pavilion, dance club, or live club consists of direct
and indirect sound —early reflections and reflections from behind.
Direct sounds reach the listener directly without any reflection.
Indirect sounds are delayed by the distance of the ceiling and walls.
These indirect sounds are an important element of the acoustic surround effect.
• The following DSP modes are provided with this unit:
• These DSP modes can be used to add acoustic surround effects while reproducing
stereo analog or linear PCM digital signals.
• When one of the DSP modes is selected,the DSP indicator lights up on the display.
Press the DSP /DPL II Mode button.
DSP modes available according to the input signal format
O : Possible, X : Not possible
Provides a clear vocal and simulates the feeling of a concert hall. HALL
Simulates the feeling of a theater. THEATER
Simulates the spacious feeling of a pavilion with a high ceiling. PAVILION
Simulates the sound of a dance club with a throbbing bass beat. DANCE CLUB
Simulates the feeling of a live music club with a low ceiling.
➠➠
➠
➠
➠
LIVE CLUB
• This function works only in the STEREO Mode.
To increase Effect level
Adjusting DSP Sound Parameters
You can fine-adjust DSP modes more minutely by changing
three parameters—room, liveness, and reverberation.
To increase Effect level
• The effect level can be set in steps from 1 to 4 EFFECT1 ➔
EFFECT2 ➔ EFFECT3 ➔ OFF(DEFAULT).
Each time the button is pressed the selection moves to the next
effect.
• The higher the number, the stronger the DSP surround effect will be.
Effect
Press the DSP/DPL II Effect button.
What is a Effect?
This sets the strength of
the DSP mode.
• This function works only in the DSP Mode.
• This function works only in the DSP Mode.
2 3
Press the Sound Edit button.
• Each time you press the button, the
indication on the display changes as follows:
1
Press the DSP/DPL II Mode button.
Press the Left/Right ( / ) button to
adjust the DSP sound parameter.
▲
▲
ROOM : To adjust the resonance based on the room size.
The larger this value is, the more effective the
resonance is (from 04 to 16 by 2 steps).
LIVE (Liveness) : To adjust the liveness. The larger this
value is, the more liveness is obtained
(from 04 to 16 by 2 steps).
REVERB (Reverberation) : To adjust the reverberation time
of the sound (from 0.0 msec to
1.6 msec by 0.2 msec steps).
00 F 00 00 R 00 REAR SW
Normal
indication
(canceled)
REVERB LIVE ROOM