Sennheiser WiCOS User Manual
Wicos
Advertising
Table of contents
Document Outline
- Contents
- Important safety instructions
- WiCOS - the wireless conference system
- Available system components - scope of delivery
- Overview of the components
- WiCOS wireless conference units
- WiCOS D delegate unit
- WiCOS C chairman unit
- WiCOS DV delegate unit with voting function
- For an overview of the operating elements at the rear of the conference unit, refer to page 17.
- Channel selection display E of the WiCOS DV delegate unit
- WiCOS CV chairman unit with voting function
- Multi-function display 7 of the WiCOS CV chairman unit
- Channel selection display E of the WiCOS CV delegate unit
- Rear of the conference console
- WiCOS BA Lithium-Ion battery pack
- WiCOS AP access point
- Overview of the web server
- WiCOS CASE transport case
- WiCOS wireless conference units
- Putting the conference system into operation
- Switching the components on/off
- Running a conference
- Operating a delegate unit
- Taking the floor/Making a request to speak
- Switching the microphone off/Cancelling a request to speak
- Participating in a voting session (WiCOS CV and WiCOS DV only)
- Connecting headphones (WiCOS CV and WiCOS DV only)
- Listening to simultaneous interpretation (WiCOS CV and WiCOS DV only)
- Adjusting the headphone volume
- Operating a chairman unit
- Operating a delegate unit
- Configuring the conference system
- Loading the factory default settings - “Reset“
- Calling up the web server of the access point
- Adjusting the basic settings - “Setup“
- Adjusting the RF settings - “RF configuration“
- Adjusting the conference settings - “Conference Management“
- Setting the maximum number of simultaneously active microphones (speaker limit)
- Setting the conference mode
- Setting the volume of the conference units’ built-in loudspeakers
- Setting the number of interpretation channels
- Setting the operating mode of the access point
- Monitoring initialized conference units - “Unit monitoring“
- Initializing the conference units with the access point - “Init Units“
- Setting the operating mode/functions of the selection keys A and B - “Chairman Config”
- Additional functions - “Service“
- Eavesdropping protection and encryption - “Encryption”
- Transporting the conference system
- Integrating WiCOS into a wired conference system
- Set up for integrated operation (slave mode operation)
- Connecting the access point to the SDC 8200 CU central unit
- Initializing the conference units with the SDC 8200 CU central unit
- Configuring the complete conference system - slave mode operation)
- Using stand-alone operation in parallel with slave mode operation
- Holding a conference in slave mode operation
- Using the interpretation system
- Cleaning the conference system
- If a problem occurs ...
- Accessories and spare parts
- Specifications
- Manufacturer Declarations
- Index