Sony DVW-2000 - Manual (Page 129)

Chapter 12
Setup Menus
Chapter 12 Setup Menus
12-23
Menu items in the range 700 to 799, relating to video control (Continued)
Item number
712
713
Item name
VIDEO PROCESS ON
CAP LOCK 2FIELD
VIDEO SETUP
REFERENCE LEVEL
(DVW-M2000 only)
0 MASTER LEVEL
1 INPUT LEVEL
2 INPUT VBLK CONT
3 BETACAM PB LEVEL
(DVW-M2000/M2000P)
4 OUTPUT LEVEL
(Continued)
Settings
When the function menu item CAPSTN or menu item 106 is set to 2F for 2-field
playback, select whether or not to carry out a “picture shift”.
OFF : No picture shift
ON: Carry out picture shift.
Note
To eliminate the adverse effect of the residual chrominance subcarrier component
in the Y signal that is the result of the Y/C separation, this unit automatically
applies a shift to the playback image in the H direction, so that even in 2-field
playback a satisfactory image can be obtained.
Set the video setup amounts to be removed from a recording signal and Betacam
playback signal, and to be added to a composite output signal. There are
independent settings for a recording signal (referred to below as an input signal),
a Betacam signal, and a composite output signal (referred to below as an output
signal).
Notes
• Setup removal is carried out only with respect to a Betacam format CAV input
signal (menu setting) and NTSC composite input signal. It is not carried out with
respect to other input signals.
• The setup amounts specified in this menu item have no connection with the
function menu item SETUP.
When the input signal, Betacam playback signal, and output signal settings are
“MSTER” (master), the setup amount specified for this sub-item is removed from
the input signal and Betacam playback signal, and is added to the output signal.
0.0% ... 7.5% ... 10.0%: Setting in this range, in 0.5% increments.
MSTER : Set the input signal to the master setting.
0.0% ... 7.5% ... 10.0%: Set the setup amount to be removed from the input signal
in this range, in 0.5% increments.
REMOV: Remove the setup amount in the vertical blanking interval of the input
signal.
THROU : Do not remove the setup amount in the vertical blanking interval of the
input signal.
MSTER : Set the Betacam playback signal to the master setting.
0.0% ... 7.5% ... 10.0%: Set the setup amount to be removed from the Betacam
playback signal in this range, in 0.5% increments.
MSTER : Set the output signal to the master setting.
0.0% ... 7.5% ... 10.0%: Set the setup amount to be added to the output signal in
this range, in 0.5% increments.
Sub-Item