Sony DVW-2000 User Manual

Page 45

Advertising
background image

Chapter 4

Recording and Playback

Chapter 4

Recording and Playback

4-3

Setting an initial time code value
Use the following procedure.

1

Set the CTL/TC to TC.

2

Press the F6 (TCGSET) button.

The function menu display changes as follows.

SET

EXIT

TCG

SET

00 : 00 : 00 : 00

The first digit of the time code value (8 digits:
hours, minutes, seconds, and frames) flashes.

To set all digits to zero
Press the RESET button.

3

Press the F1 (

T) or F2 (t) button to select the

digit to be changed.

Pressing the F2 (

t) button moves the flashing

digit position to the right, and pressing the F1 (

T)

button moves the flashing digit position to the left.

4

Turn the MULTI CONTROL knob or press the F3
(+)/F4 (–) button to change the value in the
flashing digit position.

5

Until all the digits are set as required, repeat steps
3 and 4.

6

Press the F5 (SET) button.

When the RUN is set to FREE in function menu
page 1, the time code value immediately starts
advancing.

Setting the time code value to the real time
With the settings in function menu page 1 set as
follows, carry out the procedure under the heading
above, “Setting an initial time code value”. In steps 3
and 4, set the value slightly after the current time, then
carry out step 6 at the instant the real time catches up
with the setting.

TCG (F1): INT
TCG (F2): PRESET
RUN: FREE
DF: DF (525/60 mode only)

Setting a user bit value
The user bit values recorded on the time code track
provide for eight hexadecimal digits, which can be
used to hold the date, time, or other information.
Use the following procedure.

1

Set the CTL/TC to UB.

2

Carry out the procedure in steps 2 to 6 under the
heading above, “Setting an initial time code
value”.
You can set each digit to any hexadecimal value,
represented by 0 to 9, and A to F.

Note

If any of the settings (to write a recording start mark)
in item G03 of the shot mark operation menu are set to
ON, then for 20 frames from each recording, assemble
editing, or insert editing start, the user bits are
overwritten with the shot mark data.

Z

1,2,3,4,5,6

RESET button

Advertising
This manual is related to the following products: