2 function menu item list, Home page – Sony DVW-2000 User Manual

Page 101

Advertising
background image

Chapter 11

Function Menu

Chapter 11

Function Menu

11-3

11-2

Function Menu Item List

The function menu has the following items.

HOME page

a) The selection of LTC or VITC depends on the setting of

F6 (TCR) in function menu page 1.

Item

F1 (VID.IN)

F2 (PB/EE)

F3 (CONFI)

F4 (CTL/TC)

F5 (MENU)

F6 (TCGSET)

Setting

Selects the input video signal.

COMPST: Analog composite signal

Y-R,B: Analog component signal

SDI: SDI signal

SG (normally not displayed): Test signal from the internal test signal generator

(For details, see setup

menu item 710 on page 12-22.)

Selects the video and audio signals output during fast forward, rewind, stop, and standby.

PB: Playback signals

EE: E-E mode signals

Selects whether or not to use the CONFI playback function when recording.

ENABLE: Use the CONFI playback function. (The CONFI indicator lights in the time data display.)

DISABL: Do not use the CONFI playback function.

Selects the time data to display in time data display area 1

(see page 2-7).

TC: Playback time code read by the internal time code reader, or recording time code. The LTC or VITC

time data type indicator

(see page 2-7) lights.

a)

UB: User bits data of playback time code or recording time code. The LUB or VIUB time data type

indicator lights, depending on whether the time code is LTC or VITC.

a)

CTL: The running time of the tape being played back or recorded, as calculated from a count of CTL

signals recorded on the tape. The time is displayed in Hours: Minutes: Seconds: Frames format.

Puts the system into setup menu mode

(see Chapter 12).

When the current setup menu settings are the same as the contents of any of menu banks 1 to 4, or the
factory defaults, the corresponding indication (1), (2), (3), or (dflt) appears.

(1): Same as menu bank 1.

(2): Same as menu bank 2.

(3): Same as menu bank 3.

(4): Same as menu bank 4.

(dflt): Same as factory defaults.

• When F4 (CTL/TC) is set to TC, a screen appears that allows you to set the initial value of the time code

generated by the internal time code generator

(see page 4-3).

• When F4 (CTL/TC) is set to UB, a screen appears that allows you to set the time code user bits

(see

page 4-3).

Advertising
This manual is related to the following products: