Operation of universal remote control – Sharp 27F641 User Manual

Page 42

Advertising
background image

42

Dimension: 140 X 215 mm

POWER (DVD/VCR)
Press to turn the VCR or DVD
on and off.

STOP
Press to stop the tape or disc.

PAUSE
Press to temporarily stop the
tape or disc during playback
or recording (VCR only).
Press again to release PAUSE.

REVERSE
Press to rewind a tape or
reverse a disc. For some VCRs
or DVDs you may need to
press STOP first, then REVERSE.

FORWARD
Press to rapidly advance the
tape or disc. For some VCRs or
DVDs, you may need to press
STOP first, then FWD.

REC
Press to begin recording.
(VCR only)

DVD SKIP
Press to jump forward to the
beginning of the next chapter/track,
or backward to the beginning of the
current chapter/track, and
automatically start to play that
chapter/track.

VCR CHANNEL
UP ( )/ DOWN ( )
Press to scan up or down through
channels on the VCR.

REMOTE KEYPAD
Use to enter two-digit code
numbers when identifying your
VCR, DVD and CATV converter.

ENTER

PLAY
Press to playback a tape or disc.

Operation of Universal Remote Control

Universal Remote Control
With the purchase of your television set you
also have received the latest innovation in
remote control technology. With its easy-to-use
push button keyboard, your Remote can
control your television set and most infrared
remote controlled VCRs, cable TV converters
and DVDs as well.

Note:

• Depending on the model, year produced,

brand and type of VCR, cable TV converter
and DVD, some models may not be compatible
with the remote control.

• Some brands may not enable channel

selection until the ENTER button is pressed.
In such case, try the following.

Example:
When you select channel 24,
(1) Press REMOTE KEYPAD “2”.
(2) Press REMOTE KEYPAD “4”.
(3) Press ENTER.
For detailed information on the use of the
Cable TV converter Box refer to their operating
manuals.

Using your Remote with your TV
After installing the batteries, press the TV/VCR
on the Remote to select the TV mode. (If you
can change the channel of the TV by pressing

CH a/s

on the Remote Control, it is in the

TV mode.)

“Identifying” VCRs, cable TV converters
and DVDs
Your Remote Control has been set at the
factory to operate your TV and many remote
controlled VCRs, cable TV converters and
DVDs. However, in some cases an easy one-
time set-up step may be necessary before the
Remote will operate accessory VCRs, cable
TV converters and DVDs.

• In this set-up step, the Remote locates and

memorizes the remote control transmitter code
for the VCR, cable TV converters and DVDs.

• Once “identified”, the Remote sends proper

signals to operate your accessory.

• This identifying step will not have to be

repeated until power to the Remote is
interrupted due to a battery failure.

Using your remote control with a VCR
Once you make certain the Remote Control
has “identified” your remote controlled VCR or
DVD, the Remote is ready to operate your unit.
The various VCR or DVD function buttons on
the Remote will not operate your VCR or DVD
if those features are not already found on your
unit.

• All VCR buttons will operate whether the

Remote is in TV or VCR modes.

• For detailed information on the use of the VCR

or DVD, refer to the operation manual of the
VCR or DVD.

27F541

42

Advertising