Inserting and removing a mini dv cassette, Inserting a cassette, Removing a cassette – Sharp VL-WD450U User Manual

Page 27

Advertising
background image

12

Preparation

SA VE

RE

C

SA VE

RE

C

Inserting and Removing a
Mini DV Cassette

Inserting a Cassette

1

Attach the power source to the
camcorder, then slide the cassette
compartment door release and open the
cassette compartment door.

• A confirmation sound is made, and the

cassette holder extends and opens
automatically.

Cassette compartment

door release

Note:

• If the hand strap is pulled too tight, it can

obstruct the opening of the cassette
compartment door and the cassette holder
may be unable to extend. Should this occur,
loosen the hand strap and open the
cassette compartment door completely.

Erasure protect tab

3

Press the

W

mark gently until the

cassette holder clicks into place.

• A confirmation sound is made, and the

cassette holder retracts automatically.

2

Insert the cassette fully with the window
facing outwards, and with the erasure
protect tab facing upwards.

4

Wait for the cassette holder to fully
retract. Close the compartment door by
pressing the center until it clicks into
place.

Removing a Cassette

Perform step 1 above, then take out the
cassette.

Cautions:

Do not try to close the cassette compartment
door while the cassette holder is extending or
retracting.

• Be careful not to get your fingers caught in the

cassette holder.

• Do not apply force to the cassette holder except

when pressing the W mark to close it.

• Do not tilt the camcorder or hold it upside down

when you are inserting or removing a cassette. It
may damage the tape.

• Remove the cassette if you will not use the

camcorder for a long period of time.

• If you do not correctly close the cassette holder in

step 3, the cassette protection mechanism of the
camcorder might eject the cassette. If this happens,
repeat the insertion procedure.

• Do not attempt to pick up the camcorder by the

cassette compartment door.

Notes:

• If the battery power is too low, you may not be able

to eject the cassette. Replace the battery pack with
a fully charged one.

• See page 88 for more information on the video

cassette tapes intended for use with this camcorder.

W

mark

Advertising
This manual is related to the following products: