Adjusting the hand strap 1, Attaching the shoulder strap 1, Using the lens cap – Sharp VL-WD450U User Manual

Page 32

Advertising
background image

17

Preparation

Preparation

Adjusting the Hand Strap

1

Open the hand strap flap (

1

) and the

grip strap (

2

).

2

Loosen the grip strap, pass your right
hand through the loop, and put your
thumb on the REC START/STOP button.
Then, pull the grip strap tight until it fits
snugly.

3

Seal the velcro fasteners of the grip
strap and the hand strap flap.

Caution:

• Do not swing the camcorder by the hand strap.

When attaching or
removing the lens cap,
press both tabs on the
top and bottom of the
cap.

When recording, hang
the hook of the lens cap
on the hand strap so that
the cap will not get in the
way.

5

6

7

4

3

2

Tabs

Attaching the Shoulder Strap

1

Remove the battery pack.

2

Hold one end of the strap and thread it
through the loop on the left side of the
power source mounting surface.

3

Loosen the strap in the buckle, then feed
the end of the strap through the buckle,
as shown.

4

Draw the strap in the direction of the
arrow to secure.

5–7

To attach the other end of the strap to

the loop on the left side of the hand
strap, open the hand strap flap,
perform the same procedure, and then
attach the battery pack.

Loop

Loop

Buckle

Hook

REC START/STOP button

Note:

• Always replace the lens

cap on the lens when the
camcorder is not in use.

Using the Lens Cap

Attach the strap of the lens cap to the hand
strap as shown below.

Buckle

Advertising
This manual is related to the following products: