Shure SM57 User Manual

Model sm57 user guide, Model sm57, Proximity effect

Advertising
background image

Model SM57 User Guide

©

2006, Shure Incorporated

27C2903 (Rev. 5)

Printed in U.S.A.

MODEL SM57

UNIDIRECTIONAL DYNAMIC MICROPHONE

The Shure SM57 unidirectional dynamic microphone is

exceptional for musical instrument pickup or for vocals. With its

bright, clean sound and carefully contoured presence rise, the

SM57 is ideal for live sound reinforcement and recording. It has an

extremely effective cardioid pickup pattern which isolates the main

sound source while minimizing background noise. In the studio, it

is excellent for recording drums, guitar, and woodwinds. For

musical instruments or vocals, the SM57 is a consistent choice of

professional performers.

Features

Frequency response tailored for drums, guitars, and vocals
Uniform cardioid pickup pattern isolates the main sound source

while reducing background noise

Pneumatic shock-mount system cuts down handling noise
Extremely durable under the heaviest use
Supplied break-resistant swivel adapter that rotates 180°
Legendary Shure quality, ruggedness, and reliability

STAGE MONITOR & P.A. LOUDSPEAKER PLACEMENT

Place the stage monitor directly behind the microphone (see

Figure 1). Locate the P.A. loudspeakers so that they point away

from the rear of the microphone. With the speakers located in

these positions, the possibility of feedback is greatly reduced.

Always check the stage setup before a performance to ensure

optimum placement.

RECOMMENDED LOUDSPEAKER PLACEMENT

FIGURE 1

APPLICATION AND PLACEMENT

Some of the most common applications and placement techniques

for the SM57 are listed in the following table. Remember that mi-

crophone technique is largely a matter of personal taste-there is no

single “correct” microphone position.

PROXIMITY EFFECT

When the sound source is less than 6 mm (1/4 in.) from the

microphone, the microphone boosts bass frequencies (by 6 to 10

dB at 100 Hz), creating a warmer and richer bass sound than when

farther away. This effect, known as proximity effect, happens in

unidirectional microphones like the SM57. The SM57

low-frequency roll-off provides greater control, allowing the user to

take full advantage of proximity effect.

GENERAL RULES FOR MICROPHONE USE

1. Aim the microphone toward the desired sound source and

away from unwanted sources.

2. Locate the microphone as close as practical to the desired

sound source.

3. Work close to the microphone for extra bass response.
4. Use only one microphone per sound source.
5. Locate multiple microphones at least three times as far from

other microphones as from the sound source.

6. Use as few microphones as practical.
7. Place microphones away from sound reflecting surfaces.
8. Add a windscreen when using the microphone outdoors, for

closeup speech, or vocals.

9. Avoid excessive handling to minimize mechanical noise.

180

°

90

°

0

°

90

°

P.A.

LOUDSPEAKERS

STAGE

MONITOR

SOUND

SOURCE

MICROPHONE

APPLICATION

SUGGESTED MICROPHONE

PLACEMENT

TONE QUALITY

Tom-Toms

One SM57 on each tom, or between

each pair of toms, 25 mm (1 in.) to

75 mm (3 in.) above the heads. Aim

each mic at the top heads.

Medium attack,

balanced sound.

On double head toms, remove the

bottom head and place a mic inside

aimed at the head.

Medium attack, bal-

anced sound.

25 mm (1 in.) to 75 mm (3 in.) above

the rim of the top head of the drum.

Aim the mic at the head.

Most “snap” from

drumstick impact

Snare Drum

If desired, place a second mic just

below the rim of the bottom head.

More “snare”

sound.

25 mm (1 in.) from the speaker,

on-axis with the speaker cone.

Most attack,

emphasized bass

Guitar & Bass

Amplifiers

150 mm (6 in.) to 300 mm (12 in.)

away from speaker and on-axis with

speaker cone.

Medium attack, full,

balanced sound

.5 m (18 in.) to 1 m (3 ft) back from

the speaker, on-axis with the speak-

er cone.

Softer attack, thin,

reduced bass

sound.

On-axis with the edge of the speak-

er cone.

Thinner, reduced

bass sound.

Brass:.3 m (1 ft) to 1 m (3 ft) away,

on-axis with bell of instrument.

Bright, clear sound.

Brass & Wood-

winds

Woodwinds: 25 mm (1 in.) to 150

mm (6 in.) away, on-axis with bell of

instrument.

Bright, clear sound.

Bell of the instrument 90° off-axis

from the front of the mic.

Softer, mellow

sound.

Vocals &

Speech

25 mm (1 in.) to 150 mm (6 in.) from

the vocalist's mouth.

Rich, warm sound.

Advertising