Sound Storm Laboratories Sound Storm Stretch Daddy D350.4 - Manual (Page 6)

6
Electrical Wiring
Fuses
Mounting the Amplifier
All SOUND STORM LABORATORIES D-SERIES amplifiers are equipped with easy top access screw terminals.
These terminals are Nickel Plated in order to ensure excellent electrical contact, and to resist corrosion.
When making electrical connections to the amplifier, please observe the following:
Use at least 8 gauge or heavier wires for power and ground connections.
Wire the amplifier directly to the car battery.
For the ground connection, use the shortest possible wire to a good chassis ground point.
Wire the Remote connection to the auto start lead of your equalizer or power antenna.
Power fuses protect both the amplifier and the electrical system of your vehicle from fault conditions.
If you must replace the fuse in your amplifier, use a fuse of exactly the same type and rating. A different
Mark the location for the mounting screw holes by positioning the amplifier where you wish to install
it and use a scribe (or one of the mounting screws) inserted in each mounting hole to mark the
mounting surface. If the mounting surface is carpeted, measure the hole centers and mark with a felt
Drill pilot holes in the mounting surface for the mounting screws and insert the mounting screws into
Note : Be sure to take note of any wires, lines or other devices in your vehicle which may be located
type or rating of fuse may result in damage or fire.
tip pen.
these holes. Tighten them securely.
behind any mounting surface!