Samsung ITP-5112L - Manual (Page 17)

ITP-5112L SETUP
INITIALIZING THE ITP-5112L
Initially the ITP-5112L IP keyset will need to be setup to operate within the users
network.The Setup Menu is also used to make changes to the keyset, in the event
that the system information should change. The option chosen via scroll button
will be highlighted.
The station numbers will be automatically set by the OfficeServ 100, the
OfficeServ 500, or the OfficeServ 7000 Series systems once the necessary infor-
mation has been entered into the IP keyset. Enter ID and password of the server,
as described below to register the phone.
See your system administrator for specific Network and Server addresses. The
addresses necessary to set up the ITP-5112L are:
• IP Address of Station
• Network Gateway Address
• IP Address of System’s MCP
• User ID
• Password
IP SETUP MENU
To get to the SETUP MODE unplug the power cord from the ITP. Press and hold
the MENU button while you plug power back
into the phone. Release the MENU button
when you see the SETUP SCREEN. If you have
a PoE (Power over Ethernet) connection, the
same procedure can be done by unplugging
and plugging the Ethernet cable into the
phone while pressing and holding the MENU
button.
Once the CONFIGURATION MENU is dis-
played, you can move to each menu in the Set
Up by using the navigation buttons and [1]-[9] dial buttons of the ITP-5112L IP
phone.
• The UP and DOWN directions buttons in the navigation button assembly are
used to move the highlighted bar up or down to the desired option.
• The LEFT and RIGHT buttons in the navigation button assembly are used to
move the highlighted bar left or right, to the desired option, move to a sub
menu and if a menu is at the last line, that menu option will be executed.
Configuration
*1.System Easy Wizard
2.System Information
3.Network Setup
4.Load & Upgrade Setup
5.System Server Setup
6.Factory Reset
7.Reboot
10
5112l_guide.qxp 5/9/2006 9:18 AM Page 16