Sharp TINSZ2602RCZZ - Manual (Page 74)

72
Set the mode switch to the PGM position.
Saving (writing) all the data
Restoring (reading) the saved data
* The message “ACCESSING CARD” will appear and stay on the display until all data is completely written or
read. When writing or reading is finalized, the message “SD FINAL” will be printed. In case an error occurs, a
corresponding error message will be printed.
If you save all the data by using an SD memory card that contains some data, the existing data will
be erased and replaced with newly saved data. If you need the existing data, use another SD
memory card.
Reading the graphic logo data
Set the mode switch to the PGM position.
* The message “ACCESSING CARD” will appear and stay on the display until all data is completely read. When
reading is finalized, the message “SD FINAL” will be printed. In case an error occurs, a corresponding error
message will be printed.
s s @ 145 A
To cancel
To execute
*
1
l
The comfirmation message is printed.
Writing and Reading of Programming Data 6
s s @ 148 A
To cancel
*
1
l
To execute
The comfirmation message is printed.
s s @ 144 A
To cancel
*
1
l
To execute
The comfirmation message is printed.
Saving and Restoring All the Data 5
A406_5 FOR THE MANAGER_SD 09.10.14 9:03 AM Page 72