Samsung Version 2.1 - Manual (Page 36)

OfficeServ Link Version 2.1 User Guide Message Monitoring
--------------------------------------------------------------------------------------------------------------------------------------------------------------------
Page 36 © SAMSUNG Electronics Co., Ltd
Successful disconnection changes the connection state of Link and indicates it
as , and changes the [Disconnect] button
from【 】to 【 】.
Chapter 5 Link Operating State View
When the communications environment setup, telephone system linkage, user management,
and device management have been completed for the Link and the Link is running normally,
each user can access to the Link as needed.
This chapter describes the operation state for Link in normal service.
Viewing Link state in Default mode
Figure 5.1 Link running in default mode
Figure 5.7 shows the normal working of Link running in default mode. While the Link is
running in this mode, the user connection state window shows the following information:
y IP address
Indicates the IP address of connected user computer.
y Port No.
Indicates the port No. used for TCP/IP communication with the Link. The port No. of
Link corresponds to that set in the communication environment. Default is 6000.