SpectraLink 410 - Manual (Page 10)

SpectraLink Corporation Link Wireless Telephones and Accessories User Guide
Link Wireless Telephone Accessories
Battery Packs
Overview The Wireless Telephone will need to have its Battery Pack
recharged periodically. The Nickel Metal Hydride (NiMH)
rechargeable Wireless Telephone Battery Pack gives you four hours
of talk time or 80 hours of stand-by time. Stand-by time is when the
phone is turned on, but you are not using it.
The Wireless Telephone also supports a Nickel-Cadmium (NiCd)
Battery Pack, which supports two hours talk time and 40 hours
stand-by.
Indications of low battery The Wireless Telephone will notify you when the charge on the
Battery Pack becomes low. If the Wireless Telephone is in use, the
BATT message will display and you will hear a soft beep through the
earpiece every six seconds. You have two minutes to complete the
call or change the Battery Pack.
The Battery Pack can be changed while the call is still in progress.
Do not press END . Quickly remove the discharged Battery Pack and
replace with a charged Battery Pack, press PWR , and then press
START to resume the call in progress.
If the Wireless Telephone is idle, you will hear a brief modulated
ring signal and the Low Battery message will display. Your Wireless
Telephone will not operate until you replace the Battery Pack.
Depending on the charging equipment you have purchased, you will
either place the Wireless Telephone in a Charging Stand to charge
the Battery Pack, or you will remove the Pack from the Wireless
Telephone and install it in the Charger.
Caution: Take care not to short the battery contacts on the Battery Pack with
metal objects such as coins, keys or paper clips. Shorting the
contacts can cause permanent damage.
Battery Pack removal and
replacement
To remove the Battery Pack, press down on the oval button above
the Battery Pack on the back of the Wireless Telephone. Slide the
Pack toward the bottom of the Wireless Telephone until it stops,
then lift up.
To replace the Battery Pack, first properly align the top of the
Battery Pack with the arrows on the label on the back of the
Wireless Telephone. Gently press and slide the Pack toward the top
of the Wireless Telephone until it snaps into place. You should not
have to force it against the Wireless Telephone.
Important
:
Only use SpectraLink Battery Packs with SpectraLink Wireless
Telephones.
Do not dip the Battery Pack in water or throw into fire.
Do not throw away the Battery Pack with your domestic waste.
Take used Battery Packs to an appropriate collection point for
recycling or send them back to your supplier or servicing agent.
Part Number: 72-0035-51-I.doc Page 10