Smart Technologies SMART Hub SE240 - Manual (Page 29)

23 | CHAPTER 2 – CONFIGURING YOUR HUB
To view a connected
video source’s input Press one of the video source input buttons on the sidebar.
The video source’s input appears.
NOTE
The default label of the S-video input button is Video One, and the default label of
the composite input button is Video Two. You can change these labels.
Configuring Language and General
System Settings
The hub’s user interface is set to English by default. You can change the language to
one of the following:
• French
• German
• Italian
• Spanish
To set the hub’s user
interface language
1. Select System > Settings.
The Settings dialog box appears.
2. Select System and Language.
3. In the Language list, select your preferred language.
4. Press Apply All.
You can view your hub’s system information, including the firmware version, Internet
Protocol (IP) address and Media Access Control (MAC) address.
To view system
information
1. Select System > Settings.
The Settings dialog box appears.
2. Press System and Language.
The system information displays.