Symbol Technologies MC9000-K - Manual (Page 251)

Spectrum24 Network Configuration 6-33
MicroAP Tab
Use the MicroAP tab to configure the mobile computer to operate as an AP. The MicroAP establishes
a single-cell wireless network for devices in mobile unit mode.
Each MicroAP requires a unique ESSID. MicroAP cells can coexist as separate individual networks
within the same site without interference. The MicroAP does not roam, but it does support roaming.
The mobile computer in MicroAP mode operates in CAM, and supports devices operating in both PSP
and CAM. The MicroAP supports up to 16 mobile computers.
Figure 6-23. MicroAP Tab
Figure 6-24.
Table 6-15. MicroAP Tab Fields
Field Description
Enable MicroAP Tap the Enable MicroAP checkbox to support MicroAP operations.
Tap the 1 or 2 Megabit Base Rate check boxes to specify the data rate within the MicroAP
cell. A MicroAP and the mobile computer are required to use the same data rate.
Frequency Hop Settings Tap the Frequency Hop Settings drop-down list to establish the Hop Set, Hop Sequence and
DTIM Delay to be used within the MicroAP cell.