Sharp XG-F315X - Manual (Page 53)

49
Useful
Features
Setting up the Projector Network Environment (“Network” menu)
If you do not want others to change the setting
for the “Network” menu, set a password.
Select “Password”, then press
ENTER
or Q.
• The screen for entering the password
appears.
1
1 1 1 1 1 Setting a Password
Press P or R to set the first digit
in “New Password”, then press Q.
2
Enter the remaining 3 digits, then
press ENTER.
• To return to the previous digit, press O.
3
Enter the same password in “Re-
confirm”, then press ENTER.
• The status for “Password” changes to
“Enable”.
4
Note
• Once after the password is set, you must en-
ter the password to change the “Network”
menu settings.
Select “Password”, then press
ENTER
or Q.
• The screen for entering the password
appears.
1
Enter the password in “Old Pass-
word” using P, R, Q and O, then
press ENTER.
Enter the password in “New Pass-
word” using P, R, Q and O, then
press ENTER.
Enter the same password again in
“Reconfirm” using P, R, Q and O,
then press ENTER.
Note
• If you do not need the password protection
for the “Network” menu settings anymore,
press ENTER without entering new password
in steps 3 and 4.
• To cancel the password settings, press
RETURN.
If you forget the password
If you forget the password, perform the fol-
lowing procedure to delete it, then set a new
password.
On the projector, press
S
→
T
→
S
→
T
→
S
→
T
→
U
.
Note
• If ENTER is held down for more than 5 sec-
onds, the operation buttons on the projec-
tor will be locked. (See page
48 .)
• You cannot use the buttons on the remote
control to delete the password.
2
3
4
a
Setting a Password
a
Changing the Password
Menu operation n Page 39
SEL./ADJ. ENTER END
Pict. SCR PRJ Network Help
Password Disable
DHCP Client Off
TCP/IP
MAC Address
Projector
X X : X X : X X : X X : X X : X X
X X - X X X X
4
2
3
1
Setting the Password
Old Password
New Password
Reconfirm
–
– – – –
– – –
– – – –
Network