Sony RDR-HXD970 - Manual (Page 70)

70
4
Select the programme position you
want to check using M/m.
To change the input source, press the red
button (“Source”).
To change the programme position, press
the green button (“Prog. No.”), then enter
a programme position number using the
number buttons, and press ENTER.
b Note
To receive from the recorder a programme position
that can be received by either the set top box
receiver or the recorder, change the input source in
step 4.
If any programme positions are unused or
contain unwanted channels, you can hide
them.
1
Select “Editor” in the Menu Bar, and
press ENTER.
2
In the left column, select the
programme position you want to hide
or display using M/m.
3
Press the red button (“On/Off”).
The disabled positions will turn grey.
To show the disabled positions, press the
red button (“On/Off”) again.
b Notes
• You cannot record a programme position if it is
not set in “Aerial Reception Settings (Analog
Tuner)” (page 133) even if it is set to “On” in the
“Editor” in the Menu Bar.
• If you are using your set top box receiver to
receive programmes (when the set top box
receiver is connected to the recorder using a
SCART cord only, page 17) and are able to
receive the same programme with both the set top
box receiver and the recorder, change the
“Source” to receive the programme with the
recorder’s tuner.
Disabling programme positions