Sony CMT-CP300 - Manual (Page 7)

7
Getting Started
3 For models with a voltage selector, set
VOLTAGE SELECTOR to the local
power line voltage.
110V-120V
220V-240V
VOLTAGE
SELECTOR
4 Connect the power cord to a wall outlet.
If the plug does not fit the wall socket,
detach the supplied plug adaptor (only for
models equipped with an adaptor).
To turn on the system, press @/1.
Inserting two size-AA (R6)
batteries into the remote
control
E
e
e
E
Tip
When the remote no longer operates the system,
replace both batteries with new ones.
Note
If you do not use the remote for a long period of time,
remove the batteries to prevent possible damage from
battery leakage and corrosion.
Setting the time
1
Turn on the system.
2
Press TIMER SET on the remote.
If you are setting the clock for the first time,
go to step 5.
3
Press
.
/
>
on the remote
repeatedly until “CLOCK” appears in
the display.
4
Press ENTER on the remote.
The hour indication flashes.
5
Press
.
/
>
on the remote
repeatedly to set the hour.
6
Press ENTER on the remote.
The minute indication flashes.
7
Press
.
/
>
on the remote
repeatedly to set the minute.
8
Press ENTER on the remote.
The clock will begin operating.
To reset the system clock
Start over from step 1.
Saving power in standby
mode
Press DISPLAY on the remote repeatedly
while the system is turned off.
The system switches as follows:
Clock display y Power Saving Mode