Sony CMT-HX80 - Manual (Page 30)

CMT-HX80R.GB.3-452-364-11(1)
0 GB
To reset the system to factory settings
If the system still does not operate
properly, reset the system to factory
settings.
Use buttons on the unit to reset the
system to its factory default settings.
1
Disconnect and reconnect the power
cord, and then turn on the system.
2
Press /CANCEL  , DSGX  and
/  at the same time.
All user-configured settings, such as
preset radio stations, timer, and the
clock, are deleted.
Messages
CD/MP3 player, Tuner
Complete!: The preset operation ended
normally.
LOCKED: The disc tray does not open.
Contact your nearest Sony dealer.
No Disc: There is no disc in the system,
or you have loaded a disc that cannot
be played.
No Preset (DAB only): There is no
stored preset station.
No Service (DAB only): There is no
supported DAB broadcast in your
country or region.
No Step: All of the programmed tracks
or files have been erased.
Over: You have reached the end of the
disc while pressing   during
playback or pause.
Push STOP!: You pressed PLAY MODE
 during playback.
Reading: The system is reading
information of the disc. Some buttons
are not available.
Step Full!: You tried to program more
than 26 tracks or files (steps).
TIME NG!: The Play Timer start and end
times are set to the same time.
USB device
Complete!: The audio file or folder on
the USB device has been erased.
Device Full!: The USB device is full.
Erase Error!: Erase of audio files or
folders on the USB device failed.
Error: The USB device could not be
recognized or an unknown device is
connected (page 28).
Fatal Error!: The USB device has been
disconnected while transferring to or
erasing audio files or folders on the
USB device.