4checking the size of a placed original, Manually setting the scanning size, Auto – Sharp AR-M455N User Manual

Page 84: Auto original exposure, Touch the [original] key, Touch the desired original size key, Touch the [ok] key

Advertising
background image

4-5

4

CHECKING THE SIZE OF A PLACED
ORIGINAL

If the placed original is a standard size, the size will be automatically
detected (automatic original detection function) and displayed in the touch
panel. Make sure that the correct size has been detected.
(A) :The original size is displayed.
(B) :[AUTO] appears when the automatic original detection function is

operating.

If you have loaded a non-standard size original or wish to change the
scanning size, you can follow the steps below to manually set the original
scanning size. (For the standard sizes, see "Original size detection
function" on page 4-3.)

Manually setting the scanning size

If you load an original that is not a standard size (such as an AB size), or if the size is not detected correctly, you must
touch the [ORIGINAL] key and set the original size manually. Perform the following steps after placing the document
in the automatic document feeder or on the document glass.

1

Touch the [ORIGINAL] key.

2

Touch the desired original size key.

[AUTO] is no longer
highlighted. [MANUAL]
and the original size key
you touched are
highlighted.

If you wish to select an AB size, touch the
[AB/INCH] key and then touch the desired
original size key.

[AB] is highlighted and
AB size keys are
displayed. To return to
the inch palette, touch
the [AB/INCH] key once
again.

If a non-standard size original is placed in
the document feeder or on the document
glass, touch the [SIZE INPUT] tab and then
enter the X (width) and Y (length)
dimensions of the original.

X is initially selected.
Enter the X dimension
(width) and then touch
the Y(

) key and enter

the Y dimension (length).
X can be from 2-1/2 to 17
inch, and Y can be from
2-1/2 to 11-5/8 inch.

If you frequently use originals that are the same
non-standard size, you can store the size as
explained in "STORING, DELETING, AND USING
ORIGINAL SIZES" on the following page. This will
save you the trouble of manually entering the size
each time you use that original size.

3

Touch the [OK] key.

You will return to the initial screen.

4

The selected original size appears in the
top half of the [ORIGINAL] key.

AUTO

AUTO

ORIGINAL

EXPOSURE

0

8 x11

1/

2

(B)

(A)

NOTE

If a non-standard size original is loaded (including special sizes), the closest standard size may be displayed,
or the original size may not appear at all.
If "CANCEL DETECTION AT DOCUMENT GLASS" is enabled in the key operator programs (see page 11 of
the key operator’s guide), automatic original detection at the document glass will not operate. In this case,
follow the steps below to manually set the original scanning size.

AUTO

AUTO

ORIGINAL

EXPOSURE

0

STANDARD SIZE

SIZE INPUT

INCH

AB

OK

5

X

8

5

X

8 R

8

X

11R

8

X

11

8

X

13

8

X

14

11

X

17

1

/

2

1

/

2

1

/

2

1

/

2

1

/

2

1

/

2

1

/

2

1

/

2

A5

B5

A5R

A4

B4

A3

STANDARD SIZE

SIZE INPUT

INCH

AB

OK

A4R

B5R

(2 1/2 11 5/8)
inch

(2 1/2 17)
inch

X

Y

X

Y

STANDARD SIZE

SIZE INPUT

17

11 5/8

OK

AUTO

ORIGINAL

EXPOSURE

0

A4

Advertising