Scanning sequence examples, Errors while scanning, Decoding preferences parameter defaults – Symbol Technologies 72E-86039-04 User Manual

Page 62: Own in the

Advertising
background image

5 - 2

Symbol DS6708 Digital Scanner Product Reference Guide

Scanning Sequence Examples

In most cases scanning one bar code sets the parameter value. For example, to disable the decode aiming pattern,
scan the Disable Decode Aiming Pattern bar code listed under

Decode Aiming Pattern on page 5-5

. The digital

scanner issues a fast warble beep and the LED turns green, signifying a successful parameter entry.

Other parameters require scanning several bar codes. See these parameter descriptions for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

Decoding Preferences Parameter Defaults

Table 5-1

lists the defaults for decoding preferences parameters. There are two ways to change the default values:

Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the

Set Default Parameter on page 4-4

.

Configure the digital scanner using the 123Scan configuration program (see

Chapter 12, 123Scan

).

NOTE

See

Appendix A, Standard Default Parameters

for all user preferences, hosts, symbologies, and

miscellaneous default parameters.

Table 5-1

Decoding Preferences Parameter Defaults

Parameter

Parameter

Number

Default

Page

Number

Decoding Options

Decoding Illumination

F0h 2Ah

Enable

5-3

Illumination Bank Control

F1h 3Bh

Full Illumination

5-4

Decode Aiming Pattern

F0h 32h

Enable

5-5

Low Light Enhancement

F1h 64h

Disable

5-5

Presentation Mode Field of View

F1h 61h

Default (Reduced)

5-6

Advertising