Erase – Sharp AR-M700N User Manual
The erase function is used to erase the shadow lines on copies produced when copying thick originals or books. The
erase modes that can be selected are shown below. The erase width is approximately 1/2" (10 mm) in it's initial
Eliminates shadow lines around the edges of
copies caused when heavy paper or a book is used
as an original.
Eliminates shadow lines produced by the bindings
of bound documents.
EDGE + CENTER ERASE
Eliminates shadow lines around the edges of copies
and eliminates the shadow at the center of copies.
Touch the [ERASE] key on the special
The erase setting screen
The erase icon (
also appear in the upper
left of the screen to
indicate that the function
is turned on.
Select the desired erase mode.
Select one of the three
erase modes. The
selected key will be
Adjust the amount of erase and touch the
to set the erase width to
any value from 0" to 1" in
increments of 1/8" (0 to
10 mm in 1 mm).
Touch the [OK] key on the special modes
You will return to the main screen of copy mode.
The initial setting for the erasure width can be changed in the key operator programs to any value from 0 to 1" (0
to 20 mm). (Page 14 of the Key operator's guide)
When erase is used, edge erase takes place at the
edges of the original image. If you also use a ratio
setting, the edge erase width will change according
to the set ratio.
To cancel the erase function, touch the [CANCEL]
key on the erase setting screen (step3).