Sharp AR-M700N - Manual (Page 26)

1-16
TURNING THE POWER ON AND OFF
The machine has two power switches. The main power switch can be found at the upper right after the front cover
is opened. The power switch is located at the upper left of the right side of the machine.
The two switches are normally used as follows:
Main power switch: Normally kept in the ON position.
(Be sure to keep ON when using the
fax function.)
Power switch : Turn to ON position before using
the machine.
Turn OFF at night when the
machine is not used.
Main power switch ON, Power switch ON
The copy, printer, fax*, Internet fax*, network
scanner*, and document filing functions can be
used. If the machine is not used for a certain interval
after turning on the power switch, the machine will
automatically enter a reduced power consumption
state (preheat mode or auto power shut-off mode
(see page 1-8)).
* The required options must be installed to use
these functions.
Main power switch OFF, Power switch ON
The copy, printer, fax, Internet fax, network scanner,
and document filing functions cannot be used.
Power switch Main power switch
"OFF" position
"ON" position
CAUTION
Before turning off the main power switch, make sure
that the communication and data lights are not
blinking on the operation panel. Turning off the main
power switch or unplugging the power cord while the
lights are blinking may damage the hard disk and
cause the data being stored or received to be lost.
Main power switch ON, Power switch OFF
Set the switches in this way at night or at other times
when the machine is not being used. The touch
panel cannot be used, however, the following
functions will remain operational:
When the fax option is installed:
Automatic fax reception, timer transmission
(automatic transmission at a specified time), and
transmission when a polling request is received from
another machine (remote transmission, relay
broadcast transmission)
When the network scanner option is installed:
Automatic Internet fax reception
Main power switch OFF, Power switch OFF
The copy, printer, fax, Internet fax, network scanner,
and document filing functions cannot be used.
Turn both switches off and unplug the power cord if
you suspect a machine failure, if there is a bad
thunderstorm nearby, or when you are moving the
machine.