Sharp AR-M700N - Manual (Page 52)

MISFEED REMOVAL
2-24
■ ■ ■ ■ Misfeed in the tray 5
1 Open the side cover.
2 Remove the misfed paper.
Be careful not to tear the
misfed paper during
removal.
3 Gently close the side cover.
4 Close the bypass tray.
5 Open the top cover of tray 5.
6 Open the top cover and remove the misfed
paper.
After removing the
misfed paper, close the
top cover.
7 Remove tray 1 - tray 2.
Grasp the finger hold
and gently open the unit.
Pull the tray all the way
out until it stops.
8 Remove the misfed paper.
Check the paper
transfer unit inside the
tray and remove any
misfed paper.
9 Gently close paper tray 1 - tray 2.
Push the tray all the way
back in.
Make sure that the
misfeed message no
longer appears (the
normal message display
should appear).
NOTE
If a misfeed occurs in the following situation, push
tray 1 - tray 2 back in to close it and then pull the tray
out again:
● A misfeed occurs during printing from tray 5 while
paper is being loaded in tray 1 or tray 2.