Sharp AR-M700N User Manual

Page 64

Advertising
background image

FINISHER AND SADDLE STITCH FINISHER

3-8

Replacing the cartridge in the saddle stitch finisher

Only when the saddle stitch finisher (AR-F16) is installed.

1

Open the lower cover of the saddle stitch
finisher.

When an optional
inserter is installed,
open the front cover of
the inserter before
opening the lower cover
of the finisher.

2

Slide out the saddle stitch unit carefully
toward the front.

3

(1) Grasp the grip of the saddle staple
holder and pull it out.
(2) While still grasping the grip, rotate the
saddle staple holder 90° in the direction of
the arrow (rotate to the right).

4

Remove the empty staple case and set a
new one.

Replace both staple
cases with new ones.
Remove the cover from
the staple cartridge and
then install the cartridge.

5

Return the saddle stitch holder and the
saddle stitch unit to their respective
original positions.

6

Make sure that the finisher is firmly
attached to the machine and that 11" x 17",
8-1/2" x 11"R, or 8-1/2" x 14" (A3, A4R, or
B4) size paper is loaded.

If one of the above paper sizes is not set, test
stapling cannot be performed.

7

Close the lower cover of the finisher.

Test stapling is
automatically performed
on a blank sheet.
This operation is carried
out to avoid blank
stapling.

(1)

(2)

NOTE

If test stapling fails to take place, repeat steps 1 to 7.

Advertising
This manual is related to the following products: