SRS Labs Plasma Display Panel Television - Manual (Page 23)

English - 23
1 Press the MENU ( ) button to display the menu.
2 Press the … or † button to select Setup, then press the ENTER/OK ( )
button.
3 Press the … or † button to select PC, then press the ENTER/OK ( ) button.
4 Select the required option by pressing the … or † button, then press the
ENTER/OK (
) button.
Available options: Image Lock, Position, Auto Adjustment, Image Reset
5 When you are satisfied with your setting, press the ENTER/OK ( ) button.
6 Press the EXIT button to exit.
◆ Image Lock: Coarse/Fine
The purpose of picture quality adjustment is to remove or reduce picture noise.
If the noise is not removed by Fine-tuning alone, then adjust the frequency
as best as possible (coarse) and Fine-tune again.
After the noise has been reduced, re-adjust the picture so that it is aligned
on the center of screen.
1 Press the … or † button to select Coarse or Fine, then press the
ENTER/OK (
) button.
2 Press the œ or √ button to adjust the screen quality, vertical stripes may
appear or the picture may be blurry. Press the ENTER/OK (
) button.
◆ Position:
Adjust the PC’s screen positioning if it does not fit the TV screen.
1 Adjust the position by pressing the …/†/œ/√ button.
2 Press the ENTER/OK ( ) button.
◆ Auto Adjustment:
Auto adjustment allows the PC screen of set to self-adjust to the incoming
PC video signal.
The values of fine, coarse and position are adjusted automatically.
◆ Image Reset:
You can replace all image settings with the factory default values.
➢
Preset to the PC mode by pressing the SOURCE ( ) button.
Setting the PC
PC
Move Enter Return
Image Lock
Position
Auto Adjustment
Image Reset
TV
Image Lock
Move Enter Return
Coarse 50
Fine 0
TV
Position
Move Enter Return
TV
Image Reset has completed.
Return
Auto Adjustment in progress
Please wait
BN68-00889W-01Eng(Spa) 9/20/06 3:15 PM Page 23