SRS Labs Plasma Display Panel Television - Manual (Page 37)

English - 37
Setting Up Your Remote Control
Setting Up the Remote to Operate Your DVD
1 Turn off your DVD.
2 Press the DVD button on your TV’s remote control.
3 Press the SET button on your TV’s remote control.
4 Using the number buttons on your remote control, enter three digits of the
DVD code listed on page 40 of this manual for your brand of DVD. Make
sure you enter three digits of the code, even if the first digit is a “0”. (If more
than one code is listed, try the first one.)
5 Press the POWER button on the remote control.
Your DVD should turn on if your remote is set up correctly.
If your DVD does not turn on after set-up, repeat steps 2, 3 and 4, but try
one of the other codes listed for your brand of DVD. If no other codes are
listed, try each code, 000 through 141.
Note on Using Remote Control Modes: DVD
When your remote control is in “DVD” mode, the volume buttons still control your
TV’s volume.
Setting Up the Remote to Operate Your Set Top Box
1 Turn off your STB.
2 Press the STB button on your TV’s remote control.
3 Press the SET button on your TV’s remote control.
4 Using the number buttons on your remote control, enter three digits of the
STB code listed on page 39 of this manual for your brand of STB. Make
sure you enter three digits of the code, even if the first digit is a “0”. (If more
than one code is listed, try the first one.)
5 Press the POWER button on the remote control.
Your STB should turn on if your remote is set up correctly.
If your STB does not turn on after set-up, repeat steps 2, 3 and 4, but try
one of the other codes listed for your brand of STB. If no other codes are
listed, try each code, 000 through 074.
Note on Using Remote Control Modes: STB
When your remote control is in “STB” mode, the volume buttons still control your
TV’s volume
continued...
e
f
r
x.
BN68-00889W-01Eng(Spa) 9/20/06 3:15 PM Page 37