Sharp VIEWCAM VL-A10H - Manual (Page 18)

V L - A 1 0 H / p p . 0 0 8 - 0 1 5 ; 0 0 / 2 / 2 / 1 8 : 0 0
G. K . A s s o c i a t e s , To k y o
Preparation
Preparation
11
4
Wait for the cassette holder to fully
retract. Close the compartment door by
pressing the centre until it clicks into
place.
Removing a Cassette
Perform step 1 above, then take out the
cassette.
Cautions:
• Do not try to close the cassette compartment
door while the cassette holder is extending or
retracting.
• Be careful not to get your fingers caught in the
cassette holder.
• Do not apply force to the cassette holder except
when pressing the PUSH mark to close it.
• Do not tilt the VIEWCAM or hold it upside down
when you are inserting or removing a cassette. It
may damage the tape.
• Remove the cassette if you will not use the
VIEWCAM for a long period of time.
• If you do not correctly close the cassette holder
in step 3, the VIEWCAM’s cassette protection
mechanism might eject the cassette. If this
happens, repeat the insertion procedure.
• Do not attempt to pick up the VIEWCAM by the
cassette compartment door.
Notes:
• If the battery power is too low, you may not be
able to eject the cassette. Replace the battery
pack with a fully charged one.
• See page 51 for more information on the video
cassette tapes for use with this VIEWCAM.
Inserting and Removing a
Cassette
Inserting a Cassette
1
Supply power to the VIEWCAM, then
slide the release and open the cassette
compartment door.
• The cassette holder extends and opens
automatically.
2
Insert the cassette fully with the window
facing outwards, and with the erasure
protect tab facing upwards.
3
Press the PUSH mark gently until the
cassette holder clicks into place.
• The cassette holder retracts
automatically.
PUSH mark
Erasure protect tab
Cassette compartment
door release