Editing, Advanced features, Cutting unwanted sequences – Sharp VIEWCAM VL-A10H User Manual

Page 54: Setting edit mode

Advertising
background image

V L - A 1 0 H / p p . 0 4 6 - 0 4 7 ; 0 0 / 2 / 2 / 1 8 : 0 0

G. K . A s s o c i a t e s , To k y o

Advanced Features

Advanced Features

47

Editing

Video editing lets you refine your videos by
removing unwanted sequences from your tape,
or transposing one sequence with another.
This VIEWCAM lets you monitor the source pro-
gram on the built-in LCD monitor without
having to connect it to an external TV or video
monitor.

Connect the VIEWCAM to a VCR with the sup-
plied audio/video cable, as shown.

Recording

Yellow: To VIDEO IN jack
White: To AUDIO IN (L) jack

Audio/video cable

(supplied)

Playback

POWER

TV/VCR SET UP

CHANNEL

REC

PLAY

STOP/
EJECT

PAUSE
/STILL

To VIDEO jack (ø2.5)

To AUDIO jack (ø3.5)

Cutting Unwanted Sequences

1

Play back the tape to be edited, and locate
the beginning and end of the sequence
you wish to cut. Write down the tape
counter readings at the beginning and end
of that sequence (see page 35). Then
rewind the tape to the beginning of the
portion that you wish to keep.

2

Load a video cassette into the recording
VCR.

3

Set the Power switch on the VIEWCAM to
VCR. Press the PLAY button (

D) on the

VIEWCAM and the Record button on the
VCR at the same time.

4

Press the Pause/Still button on the VCR to
pause recording when the source tape
reaches the beginning of the sequence to
be cut.

5

Press the Pause/Still or Record button on
the VCR to resume recording when the
source tape reaches the end of the
sequence to be cut.

To stop editing

Press the Stop buttons on the VIEWCAM and
the VCR.

Notes:
• Some of the transitions between edited sequences

may be slightly off.

• There may be picture noise during video search or

still picture playback. This does not imply a defect in
the VIEWCAM.

Setting Edit Mode

Picture quality inevitably decreases when
dubbing from the VIEWCAM to a VCR. To
minimize the quality reduction, set the
VIEWCAM to Edit mode.

1

Set the Power switch to VCR, then press
the MENU button until

appears.

2

Press the

ĭ or İ button to select “EDIT”,

then press the SET button (

B) to select

“ON”.

Notes:
• The EDIT mode does not function when the

VIEWCAM is recording.

• After you finish editing, set the EDIT menu item back

to “OFF”.

Note:
• If your VCR has a 21-pin Euro-SCART connector,

use the RCA/21-pin Euro-SCART conversion
connector (QSOCZ0033TAZZ) available from our
main parts distributor detailed on page 53.

Video

0

VIDEO

AUDIO

(L/MONO)

AUDIO

(R)

RCA/21-pin Euro-SCART
conversion connector
(QSOCZ0033TAZZ)

21-pin Euro-SCART on VCR

Audio L

Advertising