Kodak Ektagraphic III PAINTED and NON-PAINTED PROJECTORS J-E PLUS - Manual (Page 29)

Adjustments
SM4530-1 – 30APR96 29
Adjusting the SLIDE LIFT LEVER POWER
Warning
Dangerous Voltage
[1] Disconnect the main power.
Important
The older style MECHANISM SLIDE LIFT LEVER has an ECCENTRIC on it to do this adjustment.
[2] Do the removal for the MECHANISM ASSEMBLY.
[3] Place the MECHANISM ASSEMBLY on the MECHANISM RUNNING FIXTURE TL-3000.
[4] Energize the MECHANISM FIXTURE.
[5] Press and hold the SELECT LEVER down to move the SLIDE LIFT LEVER to the highest position.
[6] Measure the height of the SLIDE LIFT LEVER. Use SLIDE LIFT LEVER GAUGE TL-3001. The SLIDE LIFT
LEVER should make contact with the low surface of the SLIDE LIFT LEVER GAUGE TL-3001;
the SLIDE LIFT LEVER should not make contact with the high surface of the SLIDE LIFT LEVER GAUGE TL-
3001.
[7] Bend the SLIDE LIFT LEVER until the adjustment is correct.
Adjustment Specification
Make a 5/16 in WRENCH to do this adjustment (see the Tools section). Connect a DIGITAL VOLT METER
betweens PINS 1 and 3 (ZERO POSITION SWITCH). The DVM should measure • without a TRAY and 0 W with a
TRAY installed.
A091_0016BA
TL-3001
LEVER GUAGE
SLIDE LIFT
SELECT
A091_0016BCA
(not shown)
LEVER
SLIDE LIFT
LEVER