Knoll Systems HT201 - Manual (Page 16)

Enlarging the picture
You can enlarge a portion of the picture up to four times its normal size. The overall picture size
will remain the same and the enlarged picture will completely fill the overall picture frame.
Press ZOOM +. While the button is pressed the picture is enlarged until it becomes a maximum
of four times the normal size. Release the button at the desired size.
To reduce the size of the enlarged picture
Press ZOOM -. While the button is pressed the picture is reduced until it becomes the normal
size.
To move to the desired portion of the enlarged picture
1) Press POSITION. The button lights in red. If you don't proceed to step 2 within ten
seconds, the button goes off.
2) Press the desired portion of the cursor key while POSITION lights.
The moving directions are indicated by the eight triangle marks on the cursor key.
The picture will move in the direction pointed by the mark where you are pressing.
Note: The full size image cannot be moved because the whole image is fully displayed.
Menu operation-
Selecting the input source with the remote
Press Video or RGB. For S-Video press the video button twice.
Selecting menu options
1) The normal menu will be displayed when the flip cover is closed and the menu button is
pressed. To go to the advanced menu, open the flip cover, and then press the menu
button.
2) Adjust the normal menu features for your taste, the room brightness and source material
and content.
3) Use the advanced menu to adjust “one time” adjustments such as color temp., gamma
RGB type (normal or component), ceiling or floor, front or rear projection, language,
auto power on/off etc.
Selecting Ceiling or Floor, Front or Rear projection
1) Turn the projector on and have a source playing with an image on the screen.
2) Open the flip cover and press the menu button.
3) Use the left/right cursor to select “SETUP”
4) When the SETUP menu is displayed, use the up/down cursor to select
“PROJECTION” then press the enter (underneath) button.
5) Use the up/down cursor button to select the projection type listed below, then press
enter and leave the setup menu.
Projection Type HT201/HT211 Menu
Floor, front projection Normal
Floor, rear projection Reversed horizontally
Ceiling, front projection Reversed vertically
Ceiling, rear projection Reversed vertically and horizontally
16