Kodak Series 3 - Manual (Page 35)

Using your printer dock with a computer
www.kodak.com/go/support 28
Transferring pictures from the internal card reader
1 Make sure Kodak EasyShare software is installed (see page 22 ) and the printer
dock is connected to your computer (see page 24 ).
2 Open the accessory door on the printer dock.
3 If a digital camera is docked, remove it.
IMPORTANT: Insert the card only as shown. Do not force the card into the card slot.
4 Orient the SD/MMC card as shown, then push the
card into the card slot to seat the connector.
5 Press the Transfer button, , on the printer dock.
Kodak EasyShare software opens on your computer (if
it is installed).
The printer dock Transfer light blinks while the pictures
are being transferred. The Transfer light continues to
blink until the Transfer or Print button is pressed, or
until the connection is no longer available.
IMPORTANT: Do not insert or remove a card when the
printer dock is transferring pictures or if the
card slot light is blinking.
■ To stop transfer, or to return the printer dock to
ready status after transferring pictures, press
the Cancel button,
.
■ To remove the card, push it in, then release it. When the card is partially ejected,
pull it out.
Notched corner