Konica Minolta bizhub 163 - Manual (Page 273)

10 Performing a Scan to Server (FTP) operation
10-8 IC-206
When “AUTO DETECTION” is selected
1
If “AUTO DETECTION” was selected in step 6 and the [OK] key is
pressed, the following screen appears.
2
Press the [OK] key.
The message “SCANNING” appears, and the following screen appears
when scanning is finished.
– When scanning a document that contains multiple pages, position
the next page of the document on the original glass, and then press
the [OK] key. Repeat this step until all pages of the document are
scanned.
3
After all pages of the document are scanned, press the [Start] key.
A connection to the FTP server is established, and uploading begins.
When the transmission is finished, the message “COMPLETE” appears
and the Scan mode screen appears again.
2
Note
To stop scanning, press the [Clear/Stop] key.
If the transmission could not be completed correctly, a transmission re-
sult report is printed.
To cancel a queued transmission of scan data, press the [Function] key,
and then select “CANCEL RESERV.”. For details, refer to the User’s
Guide for fax kit FK-506.