Software setup (initial settings for m50 editor) – KORG M50 User Manual

Page 30

Advertising
background image

27

Software Setup (Initial settings for M50 Editor)

Global mode Software Setup lets you specify the default settings that the M50 Editor will use
when it starts up. This setting is saved when you execute the UTILITY command Save as Default,
and will be remembered the next time you start up.

Total Recall & Data Sync Settings

Here you can specify the editor data that will be saved and loaded as part of the song data by your
DAW software. This setting lets you save only the data you need. When the M50 Editor starts up,
the types of data that you’ve checked here will also be loaded automatically from the M50 that’s
connected to your computer. (In other words, this data will be synchronized.)
Since a data dump requires a certain amount of time, you may wish to shorten the startup time by
using the Load Data File Automatically function instead of this function, or by using the UTILITY
command Load to load a previously-saved data file into the M50 Editor.

Load data file automatically

When the M50 Editor starts up, the data file you specify here will automatically be loaded into the
editor. After this process is completed, the data you checked in Total Recall & Data Sync Setting
will be loaded via data dump.

Auto Local Control

This setting automatically sets the M50’s Local Control setting to the appropriate state when you
start up the editor. We recommend that you normally leave this parameter on. The M50’s Local
Control setting will be reset to its original state when you close the editor.

MIDI Settings

Here you can adjust settings for MIDI connections between the M50 Editor and the M50.

MIDI IN Port / MIDI OUT Port

This selects the connection port for the M50 and M50 Editor. The name of the currently connected

Advertising