Kodak 5500 - Manual (Page 49)

3-28 A-61074 April 1997
Error response defines the action taken when a document shorter
than the minimum length or longer than the maximum length is fed
into the Scanner 5500/7500.
The default for all modes is Display and Beep.
The options are:
— Display Error Message—results in an error message appearing
on the Operator Control Panel (E106–Doc Length Monitor
Warning).
— Display and Beep—results in an error message appearing on the
Operator Control Panel (E106–Doc Length Monitor Warning),
accompanied by an error tone.
— Stop, Display, & Beep—which results in the transport shutting
down, and an error message appearing on the Operator Control
Panel (E214–Re-Scan-Length Monitr Er), accompanied by an
error tone.
•
Select Error Response from the Length Monitor menu.
Single
6006
3111
Supprs
FthenR
None
Off
Off
NA NA Index Format
IA Field Width
Level Rules
IA Display Format
Adjoining IA
Batching
Length Monitor
Skew Monitor
Footswitch Patch Reader
COIN2 Port Select
OCR
Bar Code Reader
Printr Controller
Front Printer
Rear Printer
Mode Name
Overrides Off
n/a
n/a
Off
Supprs
Off
Off
MODE0
No Sav
Save & End Session
Save & Prev Menu
Don't Save & End Session
Don't Save & Prev Menu
Mode Number: 01 Mode Name: MODE01 Item #: 7.4
Mode Configuration Length Monitor
On/Off
Minimum Length
Maximum Length
Error Response
Previous Menu
Error Response
Display Error Message
Display and Beep
Stop, Display, & Beep
Previous Menu
•
Select the desired error response.
•
Press Enter.
Error response