Kodak 5500 - Manual (Page 50)

A-61074 April 1997 3-29
Skew monitor defines the options required to enable/disable the
document skew monitor, set the amount of acceptable document
skew, and what action is to be taken when document skew is
detected.
NOTE: In order for the skew monitor to operate correctly, the
following conditions must be true:
— The amount of skew must be less than 30 degrees.
— The document(s) must be center-fed.
— The document(s) fed must be at least 3 inches / 75 mm
wide.
•
Select Skew Monitor from the Mode Configuration window.
Single
6006
3111
Supprs
FthenR
None
Off
Off
NA NA Index Format
IA Field Width
Level Rules
IA Display Format
Adjoining IA
Batching
Length Monitor
Skew Monitor
Footswitch Patch Reader
COIN2 Port Select
OCR
Bar Code Reader
Printr Controller
Front Printer
Rear Printer
Mode Name
Overrides Off
n/a
n/a
Off
Supprs
Off
Off
MODE0
No Sav
Save & End Session
Save & Prev Menu
Don't Save & End Session
Don't Save & Prev Menu
Mode Number: 01 Mode Name: MODE01 Item #: 8.0
Mode Configuration Skew Monitor
On/Off
Detection Range
Error Response
Previous Menu
The following pages provide instructions on how to define the
document skew monitor options. When the skew monitor definitions
are complete, you will automatically be returned to this
window.
To close the Skew Monitor menu:
•
Select Previous Menu. Proceed to make any additional mode
configuration definitions.
Skew monitor