Kodak 5500 - Manual (Page 58)

A-61074 April 1997 3-37
NOTE: The patch reader is an accessory which must be installed
and enabled by your Field Engineer.
Patch reader defines the options required when using the patch
reader accessory.
•
Select Patch Reader from the Mode Configuration window.
Single
6006
3111
Supprs
FthenR
None
Off
Off
NA NA Index Format
IA Field Width
Level Rules
IA Display Format
Adjoining IA
Batching
Length Monitor
Skew Monitor
Footswitch Patch Reader
COIN2 Port Select
OCR
Bar Code Reader
Printr Controller
Front Printer
Rear Printer
Mode Name
Overrides Off
n/a
n/a
Off
Supprs
Off
Off
MODE0
No Sav
Save & End Session
Save & Prev Menu
Don't Save & End Session
Don't Save & Prev Menu
Mode Number: 01 Mode Name: MODE01 Item #: 10.0
Mode Configuration Patch Reader
On/Off
Transfer Patch Definition
Confirmation Tone
Level Transfer on T-Patch
Previous Menu
The following pages provide instructions on how to define the patch
reader options. When the patch reader definitions are complete, you
will automatically be returned to this window.
To close the Patch Reader menu:
•
Select Previous Menu. Proceed to make any additional mode
configuration definitions.
NOTE: If the patch reader was not defined as Present during
Accessory Configuration, the following message will appear:
The accessory that you requested is not enabled in
Accessory Configuration.
•
Press Enter to clear the message.
•
Exit from Mode Configuration; refer to the section entitled Exiting
Mode Configuration.
•
Select Save & Previous Menu.
Contact your Field Engineer to install and enable this accessory.
Patch reader